Lenze E70ACxS Application Sample i700 (PLC Designer v3) - Manual (Page 24)

Getting started - operating the Application Sample
Commissioning an axis
24
Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2 Commissioning an axis

How to proceed:
1. Motor data parameterisation
2. SoftMotion data parameterisation
3. Axis control during manual operation
4. Controller adjustment by means of oscilloscope function
7.3 Motor data parameterisation

Note!
If the Lenze Teachware case i700 is used, steps 1-4 are not required!
• The parameters are predefined and already included in the project.

How to proceed:
1. Select the desired controller from the Device View.
2. Select the Motor Commissioning tab.
3. Select the desired motor.
4. Select the desired control mode.