Lenze E70ACxS Application Sample i700 (PLC Designer v3) - Manual (Page 25)

Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
25
Getting started - operating the Application Sample
SoftMotion data parameterisation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.4 SoftMotion data parameterisation

How to proceed:
1. Select the desired axis from the Device View.
2. Select the SoftMotion Drive: Basic parameters tab.
3. Select the desired axis type.
4. Select the behaviour of the following error monitoring.
5. Select the SoftMotion Drive: Scaling/Mapping tab.
6. Select the desired scaling of the units/mounting direction.