Lenze E94AxHE Technology Application Actuating drive - Torque - Manual (Page 26)

9400 Technology applications | Actuator – torque
Parameter setting & configuration
Signal configuration
26
L
EDS94TA10020xxxx EN 1.1 - 10/2008
4.11 Signal configuration
4.11.1 Drive and motor interface
If required, the preset signal configuration of the control and setpoint inputs of the drive
and motor interface can be easily reconfigured per parameter setting of the assigned
multiplexer parameters.
Drive interface
Motor interface
Signal (Lenze setting) Control input Signal configuration
FALSE  Set controller inhibit C03130/1
FALSE  Set error C03130/2
Axis control word bit 00  Switch on drive C03130/3
DIGIN 5  Reset error 1 C03130/4
Axis control word bit 07  Reset error 2 C03130/5
FALSE  Reset error 3 C03130/6
Signal (Lenze setting) Setpoint input Signal configuration
100 %  Upper torque limit value C03141/1
-100 %  Lower torque limit value C03141/2
100 %  Adaptation of mass inertia C03141/3