Operation, Tig welder, Layout for the panel – Longevity TIGWELD 200 EX User Manual
Page 12
TigWeld 200EX 200amp AC/DC
TIG Welder
~ 12 ~
Operation
Layout for the panel
1
Positive Welding Terminal: Positive polarity output. It is important that the plug be inserted and
secured.
2
8 pin Control Socket: Is used to connect either to the trigger switch on the TIG torch, or to the
foot pedal
3
Negative Welding Terminal: Negative polarity output. It is important that the plug be inserted
and secured.
4
Shielding gas connector: Is connected to the gas input pipe of torch
.
5
Power source switch: Switch to “ON”, the welder is turned on, while switch to “OFF”, the
welder is turned off.
6
Power source input:
To connect to a 220v power source.
7
Shield gas input joint: Gas inlet for shielding gas
8
Fan: Is used for cooling the components and parts inside the welder.