Longevity FORCECUT 50i - Manual (Page 27)

Plasma Cutters www.LWELD.com
www.longevity-inc.com 23
Check List Suggestions
Connect the air supply to your LONGEVITY Plasma
Cutter and consult your owner's manual to ensure the
correct PSI. The PSI is about 65-75.
Each LONGEVITY Plasma Cutter, regardless if it
uses Pilot Arc or High Frequency technology, comes
with an air flow regulator and water catcher.
Reference the owner's manual of your LONGEVITY
Plasma Cutter for specifications and care instructions
of your air flow regulator and filter.
Check the torch of your LONGEVITY Plasma
Cutter and make sure everything is in order.
Reference the owner's manual of your LONGEVITY
Plasma Cutter to make sure all of your consumables
are clean, correct, and pieced together securely
before you begin cutting.
Gouging or piercing can be achieved by simply
lowering the amperage output and keeping with the
recommended psi. Examples on how to achieve the
desired results can be referenced in the owner's
manual of your LONGEVITY Plasma Cutter.
Now you are ready to use your LONGEVITY
Plasma Cutter safely and efficiently. Turn the
machine on and enjoy the satisfying experience of a
quality LONGEVITY Plasma Cutter.
Double check your air supply, air flow regulator and
water filter. (More on this below.)
All LONGEVITY Plasma Cutters require a solid
ground connection as close to the work piece as
practical. Remember, even though your
LONGEVITY Plasma Cutter can cut through paint
and other coatings on the metal, the ground
connection requires a clean, flush connection to the
work piece.
Utilizing the proper safety equipment is just as
important as understanding how to properly operate
your LONGEVITY Plasma Cutter. Consult the
owner's manual of your LONGEVITY Plasma Cutter