Installing the ice machine water supply – MARVEL Scientific 25CM User Manual

Page 7

Advertising
background image

INSTALLING THE ICE MACHINE WATER SUPPLY

Figure 6

Back view of

ice machine

Water supply

inlet

Water Supply

Observe and follow all local building codes when installing this

appliance.

Attach the supplied water line adapter (Figure 7) to the water

valve inlet on the back of the ice machine (See Figure 6). Be sure

the rubber washer is in place in the inlet valve nut. Bend the

1/4” copper tubing to suit your installation being sure not to kink

the tubing. Use 1/4” copper tubing for your water supply which

is available at any local hardware or plumbing supply store.

When installing a water line for this unit a shutoff valve is recom-

mended. NOTE: DO NOT USE A SELF-PIERCING TYPE VALVE.

The water line fitting supplied with your ice maker is to be used

on a 1/4 inch copper water supply line only. Do not attach a plas-

tic supply line to your unit with this fitting.

Water pressure must be at a minimum of 20 psi for proper op-

eration and a maximum of 120 psi.

Make certain all water connections are watertight after instal-

lation. Form the tubing so that it will not vibrate against the

cabinet body or kink when your ice machine is set in position.

NOTE

Rubber Washer

Adapter

Valve Fitting

Compression Fitting

Compression Nut

1/4 Diameter Copper water supply

line (supplied by customer)

From water supply

to ice maker

Figure 7

7

Advertising
This manual is related to the following products: