Using your freezer – MARVEL Scientific 25CM User Manual

Page 9

Advertising
background image

Temperature control located

behind right side of air in-

take -exhaust grille.

Should you turn off your control, allow at least five (5) minutes

before restarting in order to give the motor control time to auto-

matically reset so that it can restart the motor. Electrical power

to your unit is controlled by the temperature control located in

the front grille. (See Figure 10).

USING YOUR FREEZER

Turning on the freezer

After setting the freezer in place, leveling (see page 4), plug the

power cord into the wall receptacle. The freezer should start

after plugging in. The temperature control is factory preset to a

mid range setting. Allow the freezer to run for 24 hours so the

interior temperature stabilizes. If you wish to adjust the interior

temperature use a small bladed screwdriver pushed through

the right hand side of the grille to turn the temperature control

shaft. Turning it clockwise will make the unit colder. Turning it

counterclockwise will make it warmer. Turning it counterclock-

wise until it stops will shut off the compressor and fan motor.

Figure 10

Turn counterclockwise until

it stops to shut off the com-

pressor and fan.

9

Advertising
This manual is related to the following products: