Billion Electric Company BIPAC 8500 - Manual (Page 19)

Billion BIPAC-8500 / 8520 SHDSL VPN Firewall Bridge / Router
Chapter 3: Basic Installation
15
Factory Default Settings
Before configuring your, you need to know the following default settings.
Web Interface:
Username: admin
Password: admin
LAN Device IP Settings:
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site:
PPPoE
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
Username and Password
The default username and password are “admin” and “admin” respectively.
Attention Attention
If you ever forget the password to log in, you may press the RESET button
up to 6 seconds to restore the factory default settings.
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are
shown below.
LAN Port WAN Port
IP address 192.168.1.254
Subnet Mask
255.255.255.0
DHCP server function Enabled
IP addresses for
distribution to PCs
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP,
but you have to set the
username and password first.