Mayline Dual Base Only - Manual (Page 2)

(2)
1. Place each Lift Actuator Column Assembly (1)
upside down with the cord toward the floor.
CAUTION: Do not pinch Cord Assembly
2. Position the XR Foot (2) over Lift Actuator Column
Assembly (1) with the longer portion of the Foot
toward the front. The column front is determined by
the position of the cross channel clip welded on the
column. Position this clip to the rear.
3. Attach the XR Foot (2) to the Lift Actuator Column
Assembly (1) with four M6 x 16 mm Screws (E1) and
Star Washers (E2).
4. Place the assembled columns upright and attach
the Cross Channel (3). Position the Cross Channel
flange with end notches toward the floor. Slide the
Cross Channel bracket onto the tapered channel clip
on each Column. Gently tap the Cross Channel in
place with a Rubber Mallet to assure a tight fit.
5. In the event that you must reposition the Actuator
Cord. Gently remove the cord and strain relief from
the notch in the top of the Lift Actuator Column
Assembly (1). Position the cords so that they are
toward the center of the assembled base. Insert the
strain relief into the appropriate Column notch.
Attach Top Plate (4) to each Actuator Column with
four M6 x 16 mm Screws (E1) and Star Washers (E2).
6. Attach the Memory Switch (6), Main Cord (7), and
the 39.37 Cables (8) to the Control Box (5).
Cross Channel
notches DOWN
Cords toward
center
Cord Assembly
Cross Channel clip
on REAR of Column