New Buck Corporation DV1000 - Manual (Page 21)

CAUTION
Hot while in operation. Do Not Touch severe burns may result. Keep children, clothing,
furniture, gasoline, and other liquids having flammable vapors away.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, personal injury, or loss of life. Refer to owner’s information manual
provided with this appliance. Installation and service must be performed by a qualified
installer, service agency, or the gas supplier.
IMPORTANT: Always operate the appliance at the completely ON or the completely OFF
positions. Never use the heater at a setting between these positions as this can result in
improper combustion and excessive carbon monoxide emissions.
Keep burner and control compartment clean. See installation and operating instructions
accompanying heater.
DV1000 LOG PLACEMENT
Before placing the Logs and Embers you must first remove the Firebox Cover Door from the
appliance, see pages 3 and 4. After removing the cover door follow the instructions below and
on the following page. (The log placement is exactly the same for the Pine log set as for the
Oak log set.
1. Carefully open the box containing the logs. Remove the #1 log (Rear Log) and place it in
the rear center of the firebox behind the log holders located on the left and right sides.
2. Next remove the #2 log (Left Middle Log) and place it on the 2 pins (screws) located on the
left hand side of the burner.
3. Now remove the #3 log (Right Middle Log) and place it on the pins (screws) located on the
right hand side of the burner.
4. Locate the #4 log (Left Front Log) and place it on the pin (screw) located on the left front
bottom corner of the firebox. Next place the other end of the log on the pin (pins) located on
the left side of the top of the #1 log.
5. Place the large end of the #5 log (Front Center Log) on the pin (screw) located in the front
bottom center of the firebox. Place the other end of the #5 log on the pin located at the top
center of the #1 log.
6. Next place the #6 log (Right Front Bottom Log) on the pins (screws) located on the left
hand side of the bottom of the firebox.
7. Place the #7 log (Right Front Top Log) on to the pins located in the top of the #6 log.
8. Provided with your log set is a package of Glowing Embers (rock wool). Open the package
and tare off small pieces of the wool material and place it over the small holes (ports) lo-
cated on the front burner pan in front of logs #5 and #6. Cover the entire section of holes
(ports). *Replacement of loose (Glowing Embers) must be purchased from the original
manufacturer and application of excess loose material may adversely affect perform-
ance of the heater.
NOTE: “Wash your hands immediately after coming in contact with the wool material.
The wool can cause slight itching or burning in some cases, avoid any contact with eyes.”
Page 18