Removing specimens from the grips, Removing specimens from the grips 23 – MTS Model 685.53 Grip Control Module User Manual
Page 23
Removing Specimens from the Grips
Model 685.53 Grip Control Module
Operation
23
Removing Specimens from the Grips
Perform the following steps to remove a specimen from the grips.
Do not put anything in a crush zone when turning on hydraulic power.
Heavy specimens or specimen fragments falling from the grips can injure
you or damage test equipment.
Take adequate precautions to support heavy specimens while releasing them
from the grips.
1. If needed, provide adequate support for the specimen, and turn the upper
grip control to the release position.
2. If the specimen is broken, remove the upper portion.
3. Determine whether it is necessary to reposition the crosshead or actuator to
provide adequate clearance for removal of the lower part of the specimen.
Reposition the crosshead or actuator, as needed.
4. If needed, provide adequate support for the specimen, and rotate the lower
grip control to the release position.
5. Remove the specimen.
WARNING