MTS Series 642 Bend Fixtures - Manual (Page 33)

Series 642 Bend Fixtures Product Information Installation 33
D. Rotate the actuator to align the fixture’s lower and upper halves.
For an anti-rotate actuator, continue on through the next three steps.
E. Unscrew the four cap screws that attach the anti-rotate plate to the
bottom of the piston.
The anti-rotate plate is at the bottom of the actuator, inside the base of
the load unit.
F. Using a spanner wrench, turn the actuator to align the fixture’s lower
half with its upper half.
Loosen
Alig
Rotate