MTS Series 642 Bend Fixtures - Manual (Page 35)

Series 642 Bend Fixtures Product Information Installation 35
Install Model 642.001 Bend Fixtures—Electromechanical Systems
1. Turn the electromechanical toggle switch to the on position. Position the
crosshead as necessary to allow adequate room to install the bend fixtures.
2. Clean the mating parts on the bend fixtures and the load unit.
3. Insert the socket head cap screw through the grip and hand-tighten into the
pin adapter.
4. Insert the pin adapter into the clevis (force transducer attachment fixture,
lower mounting fixture, and so forth). Align the holes in the adapter and the
clevis and insert the pin.
5. Tighten the socket head cap screw to ensure a full contact between the bend
fixture and clevis.
Model 642.001 Bend Fixtures
Socket Head
Cap Screw
Pin Adapter
Clevis (Load Unit
Component)
Ensure full
contact