MTS Model 293-32 Hydraulic Service Manifold - Manual (Page 43)

Model 293.32 HSM Controls and Indicators
Controls and Indicators
Description Item
Main Filter 1
Pressure Gage 2
A liquid-filled, constant-read pressure gage is connected directly to the output pressure line.
A small orifice protects it against damage from rapid pressure changes.
Pilot Filter Indicator 1 3
A visual indicator is activated when the pilot pressure filter element becomes dirty.
Check Valve 4
Filter Drain HB 2 5
Control Manifold 6
Low Pressure Adjustment 7
A variable orifice is used to set the output pressure of the HSM in the low-pressure mode.
1 If you start the pump and hydraulic fluid is cold, the filter indicator may indicate a dirty filter. When this
happens: allow the fluid to warm up, reset the filter indicator, and replace the filter element only if the
indicator indicates a dirty filter again.
Model 293.32 Hydraulic Service Manifold | 43
Operation