MTS Isolation Service Manifold - Manual (Page 31)

Isolation Service Manifold Installation 31
4. Move the ISM.
The ISM can be moved on its pallet with a fork lift or it can be moved
with its lifting hoist rings
Lift the ISM only as high as necessary, and move it slowly to the
installation site.
5. Remove the chains/slings.
6. If necessary, secure the ISM.
The ISM can be secured to an adequate foundation. The base of the ISM has
a hole in each corner; diameter 13.48mm (0.531 in). Refer to the drawings
for spacing requirements.
7. Contact MTS Systems Corporation to arrange for installation services.
In the U.S. and Canada, call the MTS Call Center at 1-800-328-2255.
Elsewhere, contact your local MTS office.
Connect Hydraulics
Hydraulic connections to the ISM are made to the ports as shown on the
assembly drawings located on the product information CD (part number
100-237-112). These connections include:
• Pressure in from the HPU
• Return to the HPU
• Drain from the HPU
• Pressure out to HSM
• Return from HSM
• Drain from HSM
For optimum performance, when connecting the ISM to the HSM, keep the
distance between the two units as close as possible. Generally the ISM-02 would
be used with a 293.1X HSM, the ISM-04 would be used with a 293.2X HSM,
and the ISM-10 would be used with a 293.3X HSM. The ISMs were designed
such that the hydraulic connections match up with the associated HSM. MTS can
provide attachment kits for short-run, preconfigured components.
Hydraulic fluid
consideration
Mixing different brands of hydraulic fluid can contaminate your system.
Contaminated hydraulic fluid can cause premature wear of the hydraulic
components in your system.
Do not mix different brands of hydraulic fluid. MTS Systems Corporation
recommends using Mobil DTE-25® or Shell Tellus® 46 AW hydraulic fluid.