MTS Acumen Electrodynamic Test Area Enclosure User Manual
Page 11
Test Area Enclosure
Description
Item
Rear panel assembly
1
M6 x 1 mm x 35 mm socket low head screw
2
Top bracket
3
M6 x 1.00 mm x 12 mm buttonhead cap screw
4
M6 x 25MM x 12 mm flathead screw
5
Left side panel assembly
6
Foot mount
7
M5 X 35MM socket head screw, M5 butt fastener
8
M5 C'Bore butt fastener
9
Foot mount
10
Right side panel assembly
11
Front door assembly
12
1. Raise the crosshead.
2. Put two foot mounts (items 7 and 10) on the frame in the provided machined indents.
3. Put a M6 x 1.00 mm x 12mm buttonhead cap screw (item 4) for the top bracket on the baseplate.
Once the side panel is in place and before you tighten down the bottom screws, it makes installation easier
to secure the top side panel bracket to the frame to help hold the side panel in position while you tighten
the bottom screws to secure the side pane to the frame base. This step puts the top bracket screw where
you can reach it when the time comes.
MTS Acumen™ Electrodynamic Test System 11
Test Area Enclosure Installation