Multiquip WM45H - Manual (Page 17)

WM45H/e pLaSTeR MORTaR MIXeR • OpeRaTIOn and paRTS ManuaL — Rev. #0 (09/27/12) — page 17
initial start-up (enGine)
This section is intended to assist the operator with the
initial start-up of the mixer. It is extremely important that
this section be read carefully before attempting to use the
mixer in the field.
1. Place the engine fuel valve lever (Figure 7) to the “
On”
position.
Figure 7. Engine Fuel Valve Lever (ON Position
2. Move the throttle lever (Figure 8) away from the slow
position, about 1/3 of the way toward the fast
position
Figure 8. Throttle Lever (1/3 Start Position)
CauTIOn
dO nOT attempt to operate the mixer
until the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
3. Place the choke lever (Figure 9) in the “CLOSed”
position if starting a cold engine.
Figure 9. Engine Choke Lever (Closed)
4. Place the choke lever (Figure 10) in the “ Open”
position if starting a warm engine or the temperature
is warm.
Figure 10. Engine Choke Lever (Open)
5. Place both engine ON/OFF switches (Figure 11) in the
“ On” position.
Figure 11. Engine ON/OFF
Switches (ON Position)