Multiquip SP2S20H - Manual (Page 20)

page 20 — Sp2S20h paVeMeNT SaW • operaTioN MaNual — reV. #1 (02/17/12)
cOMpOnents
15. Forward/reverse Speed lever — Controls forward
and reverse speeds. Provides positive neutral for
engine start. alWayS place transmission engage/
disengage lever in the engage position before setting
speed lever.
16. Throttle lever — Used to adjust engine RPM speed
( SloW or FaST).
17. ignition Module — Turn switch clockwise to start
engine.
18. Charcoal Canister — A container filled with activated
charcoal that traps gasoline vapors emitted by the fuel
system.
19. Battery access panel — Allows access to the battery
for replacement or maintenance.
20. handle Bars — Used to steer and push the saw during
cutting operations. The handle can be folded down for
transportation.
Figure 3. Saw Components (Right Side/ Rear)
15
17
18
19
RIGHT-SIDE
16
REAR
26
22
24
23
20
21
25
21. engine oFF Switch — Toggle in either direction to
stop the engine.
22. Water Tank — A 5-gallon (18.95 liters) capacity water
tank provides water for the saw blade during short-run
cutting applications and dust control.
23. rear Wheels — Allows the saw to be rolled across
ground. The rear wheels are turned by the spline gears
attached to the hydraulic transmission system.
24. Wheel Clamp — Move handle down, making contact
with wheel, to avoid unwanted rolling movement. Lift
handle to release.
25. access panel (hydraulic Drive Transmission) —
Allows access to the hydraulic drive transmission that
controls the saw's forward and reverse movement by
using the forward/reverse speed lever.
26. Water Source adapter — Connects to the water
source, either to the water tank through a tube or to
a garden hose.