Multiquip SP2S20H - Manual (Page 28)

page 28 — Sp2S20h paVeMeNT SaW • operaTioN MaNual — reV. #1 (02/17/12)
inspectiOn
2. Move the handle bars (Figure 17) up or down to
operator's desired preference.
Figure 17. Handle Bar Height Adjustment
3. Tighten the height adjustment bolts to secure the
handle bars in place.
BlaDe heighT aDjuSTMeNT
This saw uses a manual raise/lower crank handle located
on the console with clockwise rotation providing lowering
action, and counterclockwise rotation providing raising and
lowering action (Figure 18).
Figure 18. Blade Height Adjustment
CauTioN
To avoid losing control of the saw, be sure to fully tighten
the adjustment bolts before operation to prevent the
bolts from loosening during cutting.
NOTICE
When moving the saw around between cutting, fully
raise the blade to avoid striking the ground with the
blade.
DeTerMiNiNg The CuT DepTh
To adjust the blade height:
1. Pull upward on the raise/lower crank handle knob.
2. Rotate the crank handle clockwise to lower the blade.
Rotate the crank handle counterclockwise to raise the
blade (Figure 18). The handle will stop rotating when
the blade has been fully raised or lowered.
When preparing to cut, your blade size determines the
depth of the cut. See Table 7 to determine the proper blade
size for your required cutting depth.
Table 7. Blade Size Selection
Diamond Blade Diameter Depth of Cut
304.8 mm (12 in.) 92.1 mm (3-5/8 in.)
355.6 mm (14 in.) 117.48 mm (4-5/8 in.)
406.4 mm (16 in.) 142.88 mm (5-5/8 in.)
457.2 mm (18 in.) 168.28 mm (6-5/8 in.)
508 mm (20 in.) 193.68 mm (7-5/8 in.)