Multiquip SP2S20H - Manual (Page 36)

page 36 — Sp2S20h paVeMeNT SaW • operaTioN MaNual — reV. #1 (02/17/12)
4. Release the latches located on either side of the air
cleaner dust pan. Remove the dust pan.
5. Remove the air cleaner element.
6. Blow low pressure air from the inside of the element
to dislodge the dust and dirt. Do not use excessive air
pressure or the element will be damaged and will need
to be replaced.
7. Replace the element if it is damaged or excessively
dirty.
8. Clean the inside of the dust pan.
9. Reinstall the element or if equipped, the precleaner
over the paper air cleaner element.
10. Reinstall the air cleaner dust pan and secure the
latches.
eNgiNe oil iNSpeCTioN
Check daily. Inspect with blade removed and saw frame
on a level surface. Keep the oil clean and at the proper
servicing level. SAE 10W-30 of SG is recommended for
general use. Do NoT oVerFill!
eNgiNe oil ChaNge
Change engine oil the first month or 20 hours of operation,
then every 6 months or 100 hours of operation.
1. Drain the engine oil when the oil is warm as shown in
Figure 38.
2. Remove the oil drain bolt and sealing washer and allow
the oil to drain into a suitable container.
3. Replace engine oil with recommended type oil as
listed in Table 4. For engine oil capacity, see Table 2.
Do NoT overfill.
4. Install drain bolt with sealing washer and tighten
securely.
NOTICE
Do NoT run the engine with the air cleaner removed
or without an element.
Figure 38. Draining the Engine Oil
eNgiNe oil FilTer ChaNge
1. Replace the engine oil filter (Figure 39) every 200 hours.
Figure 39. Oil Filter
2. Be sure to coat the seal of the new oil filter with clean
engine oil.
Fuel FilTer ChaNge
1. Replace the engine fuel filter (Figure 40) every year or
300 hours.
Figure 40. Fuel Filter
DRAIN
BOLT
(REMOVE)
SEAL
WASHER
SEAL
OIL
FILTER
Maintenance