Inspection – Multiquip LT12DAB User Manual

Page 21

Advertising
background image

LT12Dab LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #0 (06/03/11) — page 21

1. To check the engine fuel level, make sure the light

tower is placed on secure level ground with the engine

stopped.

2. Lift the light tower access door (Figure 7) opposite the

control panel. Set the door support latch in place to

keep the door open (up).

Figure 7. Adding Fuel

3. Remove the fuel cap from the fuel tank.

4. Pay attention to the fuel tank capacity when replenishing

fuel. The fuel tank cap must be closed tightly after filling.

Handle fuel in a safe container. If the container does

not have a spout, use a funnel.

5. Wipe up any spilled fuel immediately!

baTTeRY CHeCK

CauTIOn

aLWaYS fill the fuel tank with clean, fresh #2 diesel

fuel.

DO nOT fill the fuel tank beyond its capacity. DO

nOT TOp-OFF.

WaRnIng

The operator must wear the appropriate

protective equipment and clothing while

handling the battery.

Failure to wear protective equipment or clothing could

result in serious injury.

inSpeCtiOn

The 12-volt DC battery (Figure 8) is shipped dry and will

require a proper electrolyte level for operation.

Figure 8. Battery

When servicing of the battery is required, perform the

following:

„

A face shield and rubber gloves should be worn while

handling and servicing the battery's electrolyte.

„

Disconnect battery terminal clamps, and remove the

battery from the generator cabinet when servicing is

required.

„

DO nOT overfill the battery.

WaRnIng

Electrolyte is an acid and must be

handled with caution.

aLWaYS follow

servicing instructions from the electrolyte

manufacturer to ensure safety. Serious

injury can result from careless handling and

noncompliance to safety handling instructions.
Overfilling the battery may cause the electrolyte to

overflow resulting in corrosion to nearby components.

Immediately wash off any spilled electrolyte (battery

acid).

WaRnIng

When connecting the positive (+) cable

to the battery's positive (+) terminal post,

DO nOT allow the wrench or any metallic

part to come in contact with the battery's

negative (-) terminal post. This may result in an electrical

short circuit or an explosion. Always connect positive

(+) end first then negative (-) end. Always disconnect

(-) end first then positve (+) end.

NOTICE

Use only distilled water in the battery. Tap water can

reduce the operating life of the battery.

Advertising