Multiquip LT12DAB - Manual (Page 28)

page 28 — LT12Dab LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #0 (06/03/11)
nORmaL SHuTDOWn
1. If a load is attached to the generator of the light tower,
remove the load.
2. Set the four lamp circuit breakers on the control panel
to the OFF position.
3. Place the MAIN circuit breaker on the control panel to
the OFF position.
4. Wait a few seconds and observe that all four lamps
are OFF.
5. Let the engine idle for a few minutes with no load.
6. Turn the ignition key to the OFF position. Store key in
a safe location.
7. Lower light tower mast and place in stow position as
outlined in this manual.
8. Place outriggers in tow position, and remove chock
blocks.
9. Store light tower in a clean, dry location out of the reach
of children and unauthorized personnel.
emeRgenCY SHuTDOWn
1. Turn the ignition key to the OFF position and turn all
circuit breakers to the OFF position.
NOTICE
Failure to turn the breakers off may damage the
generator.
NOTICE
If servicing is required, allow lamps to cool for about
15 minutes before removing lamps.
OperatiOn