Orbit Baby Toddler Car Seat G2 - Manual (Page 15)

28
Usage Recommendations
28 29
Usage Recommendations
29
Lower LATCH
anchorages identified
by this symbol Top tether anchorages
(behind seat) identified
by this symbol
Installing with the LATCH Anchorage System cont’d
LATCH connectors must be secured to the vehicle LATCH
anchorages only. Connections to other vehicle components
could result in an unsafe installation of the car seat.
⚠WARNING⚠
Death or Serious Injury Can Occur
seat bight
This car seat can be installed on the car seat base or by itself using the
LATCH belt and connectors and top tether. LATCH belt and connectors are
included with the car seat base and can be found in their storage location in
the car seat base upright. LATCH belt and connectors, and the top tether are
also included with the car seat and can be found in their storage location in
the rear access panel.
The following diagrams show how to properly install and remove the LATCH
connectors included on the car seat base and car seat.
To Secure:
Slide LATCH connector completely onto the vehicle •
LATCH anchorage. You should hear a CLICK when
the connector locks onto the LATCH anchorage.
Check that the LATCH connector is locked onto the
•
vehicle LATCH anchorage by pulling out on it.
To Remove:
Press and hold the red release button on the LATCH •
connector.
Slide LATCH connector off the LATCH anchorage.
•