Orbit Baby Toddler Car Seat G2 - Manual (Page 59)

116
116
Using and T
raveling with Y
our Car Seat
117
Using and T
raveling with Y
our Car Seat
117
To install the sunshade:
1. Insert the plastic fittings on the
sunshade into the slots on the shell
(Photo A). The fittings should softly
click when fully inserted.
2. Stretch the backside of the sunshade
over the rim of the car seat (Photo B).
3. Snap sides of the sunshade onto the
upholstery snaps (Photo C).
To remove the sunshade:
Unsnap the sides of the sunshade.
Pull the backside of the sunshade out
from under the rim of the car seat.
Push each sunshade fitting out of its
slots from the back of the shell as you
squeeze the buttons on the fittings
(Photo D). Be careful as you remove
the sunshade because it will spring
outwards.
To stow the sunshade:
1. Open the rear access panel.
2. Gently fold the sunshade in half (Photo
E) and insert it into the pocket, rounded
side first (Photo F). The fittings should
stick out of the top of the pocket but not
interfere with closing the rear access
panel.
NOTE: If the panel will not close
easily, push the sunshade further into
its pocket.
3. The sunshade must be fully inside in
order to close the rear access panel.
sunshade
fitting
snap
A D
B E
C F
Using the Sunshade cont’d