Orbit Baby Toddler Car Seat G2 - Manual (Page 31)

Rear
-facing Installation
60
60
Rear
-facing Installation
61
61 61 61
Rear
-facing Installation
6. Open the upholstery lower panel marked
by the blue dot (Photo G).
7. Fully open both arms of the blue belt lock-
off clamp that will be closest to the center
of the vehicle in the final installation (Photo
H).
NOTE: If installing the seat in the center
position, open both arms of either lock-
off clamp. Only one clamp is needed for
a secure installation.
If using a lap-shoulder vehicle belt to
secure the car seat base, continue to Step
8. If using a vehicle lap belt, skip to Step 11.
If using a lap-shoulder vehicle belt:
8. Feed both the shoulder and lap portions
of the belt through the rear-facing belt
path openings in the shell (Photo I) and
the open arms of the blue lock-off clamp.
Buckle the seat belt buckle.
NOTE: If the crotch belt is in one
of the two shell slots closest to the
Installating the Car Seat: With Vehicle Seat
Belt
cont’d
seat back, the vehicle belt should
run in front of the crotch belt. With
the crotch belt in the most forward
shell slot, the vehicle belt should be
positioned behind the crotch belt.
9. Tighten the vehicle belt around the car
seat by pushing down on alternating
sides of the car seat rim while pulling on
the shoulder portion of the vehicle belt to
remove all of the slack (Photo J).
10. While continuing to hold the shoulder
portion of the vehicle belt, push down both
arms of the open blue clamp firmly until
they lock (Listen for a
CLICK) (Photo K).
Ensure that the belts are centered over the
clamp cams. Pushing down on the clamp
arm with the Orbit logo will make it easier
to lock the blue arm of the clamp in place.
Continue on to step 14.
NOTE: The blue lock-off clamp is
recessed in the car seat shell and will
do the final tightening when you push
down the arms of the blue clamp. It
may be difficult to close the clamp if
you have pulled the belts overly tight.
G
H
I
J
K
L