Bowflex SelectTech 5.1 Bench - Manual (Page 11)


Parts:
• (1) Bench Frame Assembly from Step 3 - Item 1
• (1) Leg Hold Down Tube - Item 4
• (1) Leg Pad Bar - Item 5
• (2) Leg Pad - Item 6
• (2) Leg Pad End Cap - Item 7
Hardware:
• (1) Pull Pin
Assembly Steps:
4-1 Attach the Leg Hold Down attachment to the Bench
Frame Assembly (1).
Begin by inserting the Leg Pad Bar (5) through the
hole in the Leg Hold Down Tube (4), leaving room
on each side for the Leg Pads.
4-2 Slide both Leg Pads (6) onto the Leg Pad Bar (5)
so that the entire assembly is centered on the Leg
Hold Down Tube (4).
Secure the Leg Pad End Caps (7) onto each end of
the Leg Pads (6).
4-3 Attach the Leg Hold Down Assembly to the Bench
as shown in the figure, with the hook portion of the
Leg Hold Down Tube (4) resting on the rubber stop
of the bench and the top portion of the Leg Hold
Down Tube aligning with the pull pin hole (20).
Secure the Leg Hold Down by inserting the pull pin
through the Leg Hold Down Tube and the bench
through the area shown (20).
STEP : Attachng Leg Hold Down Attachment
20
7
6
5
6 7
4
1