Setup sensors, Special note about the dm-100 obdii touch, Standard gauges – PLX Devices DM-100 OBDII Touch User Manual
Page 13: Analog gauges (graphical), 4 standard gauges, 4 setup sensors, 1 analog gauges (graphical)
Users Guide: iMFD User Guide
Version 2.0 May 16, 2013
www.plxdevices.com
(408)745-7591
13
3.4 Setup Sensors
Sensors are automatically detected when the gauge starts up. Detected sensors are arranged in the order
of the iMFD daisy chain connection. Up to 16 sensors can be detected and displayed on the DM-100 OBDII
Touch.
3.5 Special Note about the DM-100 OBDII Touch
If you wish to detect sensors from the SM-OBDII, you MUST connect the TX from the SM-OBD to the RX of
Sensors with the supplied 1ft serial cable. See diagram below. Be sure, you set the SM-OBDII to
TERMINATED. See section (3.3) for more information.
4 Standard Gauges
4.1 Analog Gauges (Graphical)
Analog gauges represent sensor data the same way a typical needle gauges does. Touch LEFT - RIGHT to
switch between sensors. Touch DOWN button to switch to digital gauges.