PLX Devices DM-100 OBDII Touch - Manual (Page 21)

Users Guide: iMFD User Guide
Version 2.0 May 16, 2013
www.plxdevices.com
(408)745-7591
21
If the DM-100 measures the following values and the ‘scheme’ setting is set to P1 OR P2, this means that
if the Parameter 1 is TRUE OR Parameter 2 is TRUE, a warning will trigger. Parameter 3 and 4 are ignored.
Measured values:
(Parameter 1) AFR = 14.0 FALSE
(Parameter 2) EGT = 850 TRUE
(Parameter 3) Oil = 105 FALSE
(Parameter 4) BST = 20 TRUE
Since Parameter 2 is TRUE, a warning will trigger according to the above example.
What will happen if the scheme is set to P1 AND P2? This means that if Parameter 1 is TRUE AND
Parameter 2 is TRUE, a warning will trigger. Since Parameter 1 is FALSE, a warning will not trigger.
Parameter 3 and 4 are ignored.
What will happen if the scheme is set to P1 OR P2 OR P3 OR P4? This means that if any parameter 1-4 is
TRUE, a warning will trigger. For this example, a warning will trigger.
What if the scheme is set to P1 AND P2 AND P3 AND P4? This means that all parameter 1-4 must be true
to trigger a warning. For this example, a warning will not trigger.
Several other scheme combinations are available for you to fully customize your warnings as they work on
the same principal as the example above.
When a warning triggers, a flashing red and white background will appear with “WARNING” on the top of
the screen. The parameter which is TRUE will also be displayed in the same format as 4 parameters
gauges. This allows you to see the actual value measured instantaneously.
*Please note if you are in the OBDII Sensors Pages, Intelligent Warning is NOT monitored. It is ONLY
monitored while in Standard Gauges.
*When a warning is triggered, touch RIGHT and LEFT (simultaneously for 3 seconds) will take you directly
to the warning setup menu.
7.4 General Setup