Precisionsound Multimonica II - Manual (Page 8)

8
© Copyright Precisionsound 2014 www.precisionsound.net
FX 2 Page
On the fourth page of the GUI, named “FX 2”, you can apply a delay effect and a high-quality
convolution reverb. From left to right, the controls are:
Reverb
Level: sets the volume in decibels of the convolution reverb effect.
Type: changes the impulse response of the convolution reverb. Fifteen impulse responses are available,
ranging from short springs to churches and cathedrals. You can also disable the reverb by setting this
menu to “Reverb off”.
Delay
Level: sets the volume in decibels of the delay effect.
Delay on/off: enables or disables the delay effect.
Time: sets the gap in milliseconds between delay repetitions.
Tone: sets the high-frequency damping of the repetitions generated by the delay, where 0% provides no
damping, and 100% provides full damping for a darker sound.
Feedback: sets the extent to which repetitions generated by the delay are fed back into the delay, to
produce more repetitions. At 100%, the delay continues regenerating indefinitely.
Spread: sets the stereo image of the repetitions generated by the delay, where 0% is mono, and 100% is
full stereo for a ping-pong delay effect.
The Credits Page, common to the Synth and Accordion instruments, is shown at the end of this manual.