Quadrox WebCCTV Installation Manual - Manual (Page 49)

WebCCTV Installation Manual 49
Version 4.4 Series
are using port 80 as the default. When you change to a new value, you must now enter
http://xx.xx.xx.xx:yy where yy is the new TCP port setting.
4.3.3 Changing remote desktop port
WebCCTV ships with the default remote port set to 3389 that should be forwarded in your
router in order to be able to access the unit via remote desktop. If this port needs to be
changed, follow the steps below.
1. Logon as Administrator.
2. Double Click the Support folder from the Windows desktop and select RegEdit by
double clicking.
3. Proceed through the following path HKey_Local_Machine->System->Current
Control Set->Control->Terminal Server->Winstations->RDP-TCP Select RDP-
TCP.
4. After selecting RDP-TCP, scroll down the list in the right pane until you come to Port
Number. Double click Port Number to Edit.
5. On the pop up screen select Decimal under Base and then enter the desired value in the
Value box.
6. Click OK to confirm.
7. Be sure to enter this value in the port forwarding section of your router.
A system reboot is typically required after making registry changes. Check also your
firewall settings. The new port must be added to the exception list.
4.4 WebCCTV power on after power failure
To adjust the WebCCTV server to power on again automatically after the power failure follow
the steps below:
1. Enter the BIOS settings by pressing F10 button during the initial stage of machine
booting.
2. Go to Advanced-> Power-On Options.
3. Find After Power Loss item and select Previous State value for it.
4. Exit BIOS so that the changes are saved.
By default, your WebCCTV is preconfigured to power on automatically after power
failure.
4.5 Configuring audio over the Internet
WebCCTV supports specific audio functions for the following brands:
Axis – Listen in and speak:
o M1031-W, M1054