Retsch BB 200 - Manual (Page 16)

04/05/2012 Retsch GmbH
16
General
Cleaning
An industrial vacuum cleaner and a stable, long-handled brush
are best suited for cleaning the BB 200.
The stationary breaker arm S can also be removed to allow for
sufficient cleaning of the grinding chamber. See Fig. 7
*
Unscrew the machine screws F.
* Swing back the fill hopper B.
* Grasp the breaker arm S at the grip and pull out the pin
Q.
* Lift out the breaker arm S.
The grinding chamber is now accessible.
Assemble in reverse order.
Fig. 7
!
The fill hopper may be swung back (by unscrewing the two
machine screws) only by trained personnel and only for
cleaning purposes. Operating the BB 200 without these
machine screws in place and tightened down properly is
absolutely prohibited.
Hazard of pinching fingers and hands!
!
Do not use running water to clean the BB 200.
Hazard of fatal electrical shock.
Using solvents is prohibited since the felt seals at the sides of
the breaker arms could be damaged and/or grease packings
could be washed out.