Bosch 4310 - Manual (Page 10)

-10-
Assembly
Tools Needed for Assembly And Alignment
Should be no Gap or Overlap
when Square is Flipped Over
in Dotted Position
Draw Light
Line on Board
Along this Edge
Hex “L” Wrench
(supplied) 1.5mm
Straight Edge of Board 3/4"
Thick This Edge Must be
Perfectly Straight
Multi Purpose Tool (supplied
with model 4410 only)
Combination Square Must be True
Combination Square
10mm/17mm Combination
Open End Wrench
Multi Purpose “L” Wrench 6.5mm
(supplied with model 4310 only)
Unpacking And Checking Contents
Before moving the saw: Lock the
miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly com-
pletely toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may
cause blade damage.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connec-
tions could cause a fire.
Models 4310 & 4410 Miter Saws are shipped complete
in one box.
1. Separate all parts from packing materials and
check each one with the “Table of Loose Parts” to
make sure all items are accounted for before
discarding any packing material.
2. Table of Loose Parts:
Quick- Action Clamp (Model 4410 only) - Used to
clamp workpieces.
Workpiece Clamp (Model 4310 only) - Used to
clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
( Multi purpose tool model 4410) or multi purpose
“L” wrench model 4310) - Should be stored on
the right rear base.
Rear Cord Wrap, washer and Screw - Used for
wrapping the cord
Miter Lock Knob - Used to lock the table at de
sired miter angle.
If any parts are missing, do not
plug in power cord or turn the
switch on until the missing parts are obtained and
are installed correctly.
Rear Cover Tool Storage
The Open End Wrench and Hex Wrenches are
stored on the inside rear cover of the saw. To re-
move the cover, unscrew the two top and center
thumb screws.
Disconnect plug from power source before performing any assembly, adjustment or repair
to avoid possible injury.
!
WARNING
! WARNING
!
WARNING
Thumb
Screws
BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 10