Retsch DM 200 - Manual (Page 15)

16.11.2006 Retsch GmbH
15
Doc.Nr. GB 98.740.9999
General Information
Accessories
Cleaning
You may pull out the collecting container for cleaning pur-
poses.
Open the door to clean the milling discs, the milling space
and the funnel tube.
You may now conveniently clean the entire area that has
come into contact with the material to be crushed with the
aid of a brush or vacuum cleaner.
!
Do not clean the DM200 with flowing water.
Danger from Current Surge
Only use moistened rags.
Solvents are not permitted.
The protection type of DM200 is IP 55
Service
The DM200 does not require service, although it should
be relubricated on the lubricating nipple of the shifting
sled.
Conventional lubricating grease may be used for this
purpose.
A grease gun is also available as an accessory under
the order no. 05.185.0006.
Necessary Safety Tests
The safety limit switches on the door and the collecting
container should be checked on a monthly basis to see if
they are in perfect working order:
open the door:
It may not be possible to switch on the DM200 any more
with the ON/OFF switch.
close the door:
It must be possible to start the DM200 with the ON/OFF
switch again.
pull out the collecting container:
It may not be possible to switch on the DM200 any more
with the ON/OFF switch.
push in the collecting container:
It must be possible to start the DM200 with the ON/OFF
switch again.
!
If the machine is not functioning properly, do not con-
tinue to operate it and get in contact with our customer
service.
Copyright
It is only allowed to pass on or copy this documentation
or utilise and pass on its content with the express per-
mission of Retsch GmbH.
Non-compliance engages the obligation of compensa-
tion for damage.
Modifications
We reserve the right to make technical modifications.