Retsch DM 200 - Manual (Page 16)

16.11.2006 Retsch GmbH
16
Doc.Nr. GB 98.740.9999
Safety Regulations (Table) for the DM200 from the sections
process action hazards
safety information property damage and personal
injury may be incurred if the safety
information is not observed. no claims to compensation for damage
shall be accepted whatsoever
intended use do not mill any explosive self-
igniting or fire-promoting materials danger to life and limb because of
explosion because the DM200 is not
designed to be explosion protected.
do not mill materials whose fine
proportion at a certain percentage
may lead to an explosion. danger to life and limb because of
explosion because the DM200 is not
designed to be explosion protected.
do not modify the machine and
only use the spare parts and acces-
sories approved by Retsch. otherwise the conformity with Euro-
pean directives declared by Retsch
shall be rendered invalid.
Furthermore, this leads to the loss of
all warranty claims.
packaging please store the packaging for the
warranty period. if there is a complaint and it is re-
turned in insufficient packaging, this
may jeopardise your warranty claims.
temperature fluctua-
tions protect the DM200 from conden-
sate water forming if there are
temperature fluctuations. electronic component parts may be
damaged.
transportation do not shock, shake or throw the
DM200 during transportation electronic and mechanical component
parts may be damaged.
scope of delivery if the delivery is incomplete and /
or if there is damage from trans-
portation, you have to inform the
transporter and Retsch GmbH
without delay (within 24h). under certain circumstances later
complaints may not be recognised.
ambient temperature should not fall below 5°C
should not go above 40°C electronic and mechanical component
parts may be damaged and perform-
ance data may change unpredictably.
humidity do not exceed a relative humidity
of 80% at 31°C or 50% (descend-
ing linearly) at 40°C. higher humidity may damage the elec-
tronic and mechanical component
parts and performance data may
change unpredictably.
electrical connection the network does not agree with
the values on the nameplate. electronic and mechanical component
parts may be damaged.
adjusting the gap
width do not adjust a gap width < 0.1
mm if the milling discs come into contact
with one another, they may be dam-
aged.
feeding the material
to be crushed only feed material to be crushed
when the DM200 is operating. if the DM200 starts up filled with ma-
terial to be crushed, this may damage
the mechanical component parts.
cleaning do not clean the DM200 with flow-
ing water. danger from current surge.
the protection type of the DM200 is
IP55
safety tests get in contact with customer ser-
vice if the safety equipment func-
tions improperly.. if defects are improperly repaired, this
may lead to danger to life and limb.