RKI Instruments 1017-01 - Manual (Page 15)

Model 1017-01 Operator’s Manual • 11
3. Allow the Model 1017-01 to draw sample for one minute.
4. Follow the directions in the controller’s operator’s manual for setting the span.
5. Disconnect the sample tubing from the inlet fitting.
6. Unscrew the regulator from the combustible gas calibration cylinder.
Returning to Normal Operation
1. Reconnect the incoming sample line.
2. Wait approximately one minute to allow the combustible gas reading to stabilize.
3. Follow the instructions in the controller’s operator’s manual to exit the calibration
mode.
4. Store the components of the calibration kit in a safe and convenient place.
Parts List
Table 4 lists replacement parts and accessories for the Model 1017-01.
Table 3: Parts List
Part Number Description
06-1200RK Sample tubing, 4 x 6 mm, specify length (used for internal plumbing)
17-2593RK Brass tubing insert for .25” O.D. x .17” I.D. flexible tubing (used when flexible
tubing is connected to inlet or exhaust fitting)
17-2673RK Front ferrule (for inlet and exhaust fittings)
17-2678RK Back ferrule (for inlet and exhaust fittings)
30-1016RK Pump, w/cable and connector
33-3050RK MC filter w/cartridge & flow monitor (recommended for installation external
to Model 1017-01 in inlet line)
81-0002RK-01 Calibration cylinder, 50% LEL hydrogen in air, 34 liter
81-0002RK-03 Calibration cylinder, 50% LEL hydrogen in air, 103 liter
81-0007RK-01 Calibration cylinder, 50% LEL hexane in air, 34 liter
81-0012RK-01 Calibration cylinder, 50% LEL methane in air, 34 liter
81-0012RK-03 Calibration cylinder, 50% LEL methane in air, 103 liter
81-0076RK-01 Zero air calibration cylinder, 34 liter
81-0076RK-03 Zero air calibration cylinder, 103 liter
81-1001RK Dispensing valve (with knob)
81-1054RK Regulator (demand flow)
81-1126RK Gas collection bag (2 liter)
HW-6213 Combustible gas sensor, plug-in type, LEL