RKI Instruments 1017-01 - Manual (Page 8)

4 • Model 1017-01 Operator’s Manual
Installation
This section describes procedures to mount the Model 1017-01 in the monitoring
environment and wire it to a controller.
1. Select the mounting site. Consider the following when you select the mounting site.
• Is there enough room to remove the cover and make wiring connections at the
right side of the housing and tubing connections at the bottom of the housing?
• Is there is sufficient room to perform start-up, maintenance, and calibration
procedures?
Figure 3: Mounting the Model 1017-01
4. Position the Model 1017-01 on a vertical surface.
5. Insert 3/8 inch screws or bolts through the slots in the two mounting feet to secure the
housing to the mounting surface.
7.00
6.13
3/4 NPT
5.25
9.88
1/4 O.D. Tube Fitting (2X)
.58
7.00
8.38
3/8 Mounting Bolts (2X)
2.9 Max
.88
9.9 Max