Cable shield, H2s detector red terminal block black, Controller housing – RKI Instruments 65-2427RKSS-05 User Manual
Page 11
Advertising
65-2427RKSS-05 H
2
S Detector • 7
8.
Connect the wires to the applicable controller terminal strip. See the controller
operator’s manual and the controller’s detector head specification sheet.
Figure 4: Wiring the H
2
S Detector to a Controller
9.
If using shielded cable, connect the cable’s drain wire to an available chassis ground at
the controller. RKI controllers typically have a ground stud that is a convenient
grounding location.
Cable Shield
S
Controller Housing
Controller Detector/Transmitter
Terminals, Typical Designations
H2S Detector
Red
Terminal Block
Black
+
Advertising