S&S Cycle EZFI on 2008-09 Touring Models User Manual
Page 4
![background image](/manuals/571898/4/background.png)
4
8- Remove the wires located in Table 1 from the ECM connector.
NOTE: The position numbers are located on the back of the connector. To remove the wires, insert the supplied plastic push pin into the round hole
between terminal cavities as shown in Picture 6. Make sure not to remove adjacent terminals when performing this operation.
9- Insert the EZFI™ wires into the ECM connector. The appropriate locations of the wires are found in Table 2.
Picture 6
ECM Pin #
EZFI Color
Signal/Function
23
Red
Rear Injector
28
Orange
Front Injector
37
Violet
Throttle Position Sensor
72
White
Ignition Switch
Table 2
ECM Pin#
Stock Wire Color
Signal/Function
23
Green/Grey
Rear Injector
28
White/Yellow
Front Injector
37
Brown/Violet
Throttle Position Sensor
72
White/Black
Ignition Switch
Table 1