SATEC PAS - Manual (Page 16)

R E T R I E V I N G H I S T O R I C A L D A T A
14
Adding a New Site to the Schedule
Click 'Add Site', select the site database for which you want to organize the
schedule, and then click 'OK'.
Configuring a Schedule for the Meter
Click 'Configure' or double click with the left mouse button on the site row. Click
on the 'Select logs' button, check boxes for logs you want to upload on a schedule
from the meter, and then click 'OK'. Pay attention to the Note in the previous
section.
Select a daily, weekly or monthly schedule, and adjust the start time for uploading.
Select the number of attempts to upload data in the event of temporary
communication problems or unavailability of your meter, and the delay between
attempts in minutes and seconds.
If you want to use this schedule to synchronize the clock in the meter with the PC
time, check the 'RTC Synchronization Enable' box. If your meter is secured by the
communications password, type in the password you set in the meter to allow PAS
to update the clock.
After you have configured a schedule for the site, click 'OK'.
Click 'Browse' at right and select an existing database for storing retrieved data, or
type the name for a new database and select a directory where you want to save it,
and then click 'OK'.
Activating a Schedule for the Meter
To activate a schedule for the meter, check the 'Enabled' box at left on the meter
site row.