Schwank IEP-2024 - Manual (Page 15)

15
IM110810
RD: AUGUST 2011
RL; 1A
BA
InfraSave IEP-2024 Manual
10. HEAT LAMP REPLACEMENT
The Heat Lamp will operate for approximately 5000 hours under normal conditions.
WARNING
Heater service should only be performed by a qualified electrician. Failure
to comply can result in personal injury, death, fire and property damage.
IMPORTANT
ALWAYS DISCONNECT THE HEATER FROM THE ELECTRICAL POWER SUP-
PLY PRIOR TO CLEANING, MAINTENANCE, LAMP CHANGE, OR SERVICE.
ALWAYS WEAR COTTON OR OTHER FABRIC GLOVES WHEN REPLACING HEAT LAMP.
DO NOT TOUCH THE LAMP SURFACE WITH YOUR BARE HANDS - OILS FROM YOUR
SKIN WILL CAUSE DAMAGE TO THE LAMP.
The heater requires disassembly to replace the heat lamp.
Use a container to securely store disassembled components and screws.
Step 1
Compress the width of the protective screen to retract the
wire tabs from under one edge of the heater body.
Rotate the lose edge of the screen up and away from
heater body.
Pull the screen away from heater to remove from other
edge of heater body - place safety screen in secure stor-
age.
Step 2
Remove connection box end cover .
Six (6) Phillips screws hold the end cover in place.
Remove the screws and end cover to secure storage.
Step 3
Remove 4 Phillips screws that hold connection box to
heater.
Slide out the face plate at each end of heater to expose
both ends of the heat lamp.