Step 9, Step 10, Step 11 – Schwank IEP-2024 User Manual
Page 17: Step 12, Step 13
17
IM110810
RD: AUGUST 2011
RL; 1A
BA
InfraSave IEP-2024 Manual
Heat Lamp Replacement
:
… continued
Step 9
Remove end plate from heater: 6 Phillips screws fasten
the heater body end plate in place.
Step 10
Slide cover plates and heater mounting bracket out from
top side of heater.
Remove remaining end plate from other end of heater.
Step 11
Slide Face Plate out from each end of heater.
Step 12
Remove the heat lamp retainer clip at each end of lamp.
Step 13
IMPORTANT
: Wear gloves to handle the heat lamp.
Oils from your skin will damage the lamp.
The heat lamp is fragile! Carefully slide old heat lamp out
of heater through rectangular slot in end of reflector.
Carefully install new heat lamp and clip in place.
Reverse steps above to reassemble the heater.