Schwank ecoSchwank Millivolt - Manual (Page 14)

ecoSchwank-MILLIVOLT / IL-MILLIVOLT Manual
IM090128
RD: JAN 2009
RL: 1D
BA
9.6 SUGGESTED MOUNTING DISTANCE FOR COMFORT**
*Reflector with venturi must be in upper position
** These mounting distances are suggested and are subject to on sight conditions. If in doubt, please
contact your distributor.
Page 11
Since most installations will differ in many details, these instructions are general. Sound judgment must
be exercised and careful supervision is essential to assure the installation will be made in the best man-
ner possible for trouble-free operation and at minimal cost. All systems must be done in accordance with
acceptable practices, local codes, and applicable standards.
This heater is suitable for reflector mounting angles up to 30 degrees along the short axis Improper angle
mounting can result in overheating of controls and combustible materials.
IMPORTANT: For either horizontal or angle mounting, the long axis of the heater must be level. Use
only non-combustible mounting hardware.
NOTE: It is the responsibility of the installer to insure that the chosen suspension system will support at
least 200 lbs.
MOUNTING HEIGHTS:
ecoSchwank-M / IL-M 6 10 13 18 26
Distance to floor 12’ 16’ 20’ 24’ 28’
Maximum heater spacing 16’ 22’ 28’ 34’ 39’
Maximum distance between heater rows 25’ 30’ 40’ 50’ 70’
HORIZONTAL suggested mounting distance for comfort.*
ecoSchwank-M / IL-M 6 10 13 18 26
Distance to floor 12’ 13’ 17’ 20’ 22’
Maximum heater spacing 16’ 22’ 28’ 34’ 39’
Maximum distance between heater rows 25’ 30’ 40’ 50’ 70’
ANGLE suggested mounting distance for comfort.*