Schwank STR-USA - Manual (Page 10)

SP-MSTR-AU-05A
STR Manual
RD: NOV, 2003
RL: 5
KH
Page 6
FIGURE 6
2. Assemble two shade end plate hangers by attaching 1 of the shade end plates to the
hanger plate using the supplied slotted screws and nuts. If the system is longer
than 10’, additional shade plate hangers must be assembled. To assemble a shade
plate hanger, attach 2 of the shade end plates to opposite sides of the hanger plate
and screws using the supplied slotted screws and nuts. The shade end plate hangers
are used on each end of the total system. The shade plate hanger is used in between
shades and allows the shade to be mechanically attached to either side of the
hanger. See Figure 7. An alternate method is to place only the hanger plates on the
tube and assemble the shade end plates after the system has been fully or partially
suspended. The shade end plates can be mounted to the hangers and then install
the shades or install the shade end plates on both ends of the shade and attaching
the shade to the plate hangers. If this method is used, attach the shade nearest the
burner box first and work down toward the opposite end.
FIGURE 7
7. SUSPENSION SYSTEM
1. Attach the burner box to the flanged aluminized or alumatherm tube using the
bolts, nuts, and washers provided. Ensure that the gasket is sandwiched between
the two flanges. See Figure 6.