Brother HL-1060 - Manual (Page 50)

III-11
Note: Follow instructions below when installing the thermistor in the fixing unit.
• Place the cleaner felt of the cleaner ASSY under the heat roller.
• Place the end of the thermistor on the heat roller.
• Insert the boss1 of the thermistor into the hole of the fixing unit frame.
• Do not place the thermistor on the boss2 of the fixing unit frame.
,, ,,,
,,
,,,
,,,,
,,,,,
,,,,
,,
,,
,,
,,,
Fig. 3.16
(7) Remove the two screws.
(8) Open the fixing unit cover along the open side of the fixing unit cover.
Fig. 3.17
Screws
Fixing unit cover
Shaft
Fixing unit
cover
Pressure roller
Thermistor
Cleaner ASSY HR
Boss2
Fixing unit frame
Heat roller
Boss1
Cleaner ASSY
Fixing unit frame