SDC S6100 SERIES REVERSIBLE PANIC/FIRE EXIT - Manual (Page 17)

C. MOUNT LATCH ASSEMBLIES
1. Attach latch mounting brackets to top and bottom latch assemblies
2. Insert top latch assembly into top of the door and fasten to the mounting plates
with the screws provided (figure 3-1).
3. Insert bottom latch assembly into bottom of the door and fasten to the mounting plates
with the screws provided (figure 3-2).
P:\INSTALLATION INST\Mechanical Hardware\INST-S6800.vsd Rev - 12/10 Page 5
Latch mounting bracket
Top latch assembly
Mounting
plate
Figure 3-1
To
p o
f d
oo
r
Mounting
plate
Bottom latch
assembly
Latch mounting
bracket
Figure 3-2
Bo
tto
m
of
do
or
D. ADJUST VERTICAL RODS
1. Place the rod length locator through the cut-outs on the inside face of the door. Hook a shaft
connector with the small stud on the locator. When the shaft connector is raised to as level as
possible, the holes C or D in the locator should align with the cut-outs A or B (figure 4-1).
2. If the C or D holes in the locator do not align with their respective cut-out, then the vertical rod
length is incorrect and must be adjusted.
Top latch
assembly
Bottom latch
assembly
Rod Length
Locator
Stud for
hooking
Cut-Out A
Cut-Out B
Hole C
Hole D
Figure 4-1
Top shaft
of Device
L
C
Bottom shaft
of Device
L
C