SDC E75 STANDALONE ELECTRONIC LOCKSET - Manual (Page 2)

P:\INSTALLATION INST\ACCESS CONTROLS\E75\INST-E75.vsd REV A 05-13 Page 2
Install the Keypad and
Battery pack to the door
Pass a small pull wire through the
raceway hole. This pull wire will
be used to bring wires from the
lock, to the keypad wiring area.
Pull
Wire
Install the Lockset.
(Refer to lockset
instructions) Attach the pull wire to the
wires from the lock. Pull the
lock wires through the
raceway as you insert the
cylindrical lock.
Pull Wire
Cylindrical
Lock Wires
Plug in the keypad to the battery pack.
Attach wires from the lockset to the
keypad using the chart below.
Specifications
Power 4AA Batteries (Alkaline only) or
External 12VDC Power @ 30mA
Inputs 1 Request-To-Exit
1 Door Position Switch
Output SPDT Contacts 1A @ 30VDC Relay
Temperature -20 F to +130 F (-30 C to +54 C)
Humidity 5% to 95% non-condensing
Latch Bolt 9/16”
Backset 2-3/4”
Strike 4-7/8” ANSI A115.2
Door 1-3/4” to 2-1/8”
Thickness
Additional Wire Connections
12VDC Ext Power In
Request-To-Exit
Door Position Switch
Auxiliary Relay
System Reset
= RED(+) / BLK(-)
= BLU(N/O) / BLK(COM)
= GRY(N/O) / BLK(COM)
= ORG (N/C)
WHT(COM)
YEL(N/O)
= BRN / BRN
Keypad Lockset
RED/WHT
WHT/BLK
RED
WHT
Function
Motor
Output +
_
REX (C)
REX (N/C)
REX (N/O)
WHT/RED
ORG/RED
YEL/RED
BLK
BLU
1 2 3
4 5