Sensaphone SAT4D - Manual (Page 14)

14
SAT4D User’s Manual
the sky at up to a 45 degree angle in all directions. An optional pole
kit is available for this purpose (Part # FGD-SAT4D-PKIT).
SAT 4 D
1 0 0 % C O V E R A G E
Fig 1. SAT4D Mounting Location .
INSTALLATION USING THE pOLE KIT (OpTIONAL)
1) Locate an area where you will be installing the SAT4D. Make
sure you can drive a pipe at least 3’ into the ground without dis-
turbing any electrical wires, gas pipes, water pipes, telephone or
cable wires, etc… You may need to contact your local utilities
beforehand.
2) Loosen the two set screws and remove the 1” pipe from the
inside of the 2” pipe. Drive the 1” pipe three feet into the ground.
3) Slide the 2” pipe over the 1” pipe and tighten the two set screws.
4) Attach the NEMA-4X enclosure to the top of the pipe using the
2 U-Bolts (see figure).
3’ below surface
5’
Set screws
U-Bolts