Sensaphone CELL682 - Manual (Page 45)

43
Chapter 6: pump Control
prograMMing for pUMp control
To program the unit for Pump Control, click on the Outputs tab.
Figure 2: Output properties showing pump control
Next, click on the Pump Control link. This will bring up the pump mode setup
screen. Next, select the type of pump control you want to do:
• Drain Analog Level
• Drain Dry Contact Floats
• Fill Analog Level
• Fill Dry Contact Floats
Figure 3: Pump Mode—Analog programming
If you select one of the Analog modes, you will have to fill in the Lead, Lag, and
Pumps-Off fields. In Dry Contact Float mode these fields are disabled. Enter the
appropriate values and click OK or Apply.
Next, click on the output to use for Pump Control. Click the drop-down box and
scroll to the bottom to select Pump Control. Click OK or Apply. This will activate
the Pump Control logic. Make sure all input devices and equipment are operation-
al and ready for use. For test purposes you may wish to use hand operated switch-
es to manually control the pumps and simply watch the system LEDs to see if the
Cell682 is functioning properly. If you are using “duplex” pump control, select the
other output and set it for Pump Control mode also. After verifying that the unit
is functioning properly, move your hand-operated pump switches to “Auto” and
verify that the Cell682 is properly controlling the system.