Sportsliter Solutions Two circuit remote ballast - Manual (Page 2)

Due to our continued efforts to improve our products, specifications are subject to change without notice.
Copyright © 2013 Hubbell Lighting All Rights Reserved.
For more information visit our web site: http://www.sportslighting.com/
SLS0036 SLS 2 Remote Ballast Instruction-A 1/14
Drawing Number: 268-1220-9901
Supply Wiring:
1. Connect the supply wires to the proper lugs on switch.
2. Connect ground wire (6) to the ground lug (7) (Fig.4)
3. Provide effective strain relief to prevent wire damage.
4. Comply with all national and local electrical codes.
Caution: Protect exposed wires with approved insulators.
Fixture Wiring into Enclosure:
1. Connect the male plug of wiring harness and the female harness plug
inside enclosure. ( Figure 4) Snap securely.
2. Enclosure shall be properly grounded.
3. Close door and engage the latches. A lock is optional.
These instructions are not intended to be a comprehensive guide to all
installation issues. The installer is responsible for safe, secure mounting
suitable for the application. Once the enclosure is installed, give these
instructions to the equipment owner.
TWO CIRCUIT REMOTE BALLAST
INSTALLATION AND SERVICING INSTRUCTIONS