Sportsliter Solutions SLS Remote Yoke Axial Optics - Manual (Page 2)

Due to our continued efforts to improve our products, specifications are subject to change without notice.
Copyright © 2013 Hubbell Lighting All Rights Reserved.
For more information visit our web site: http://www.sportslighting.com/
SLS0039 SLS Series Instruction-A 1/14
Drawing Number: 268-0922-9901
facing downward.
Wiring Instructions: (See Figures 2 & 3)
1. Loosen the (2) wiring cover screws
(I) and swing the cover away to
expose the wiring compartment.
2. Feed supply cord
(N) into wiring compartment through the wiring hole
(O) in the bottom of the socket housing.
3. Feed the supply cord through the appropriate rubber seal
(P) and through
the center hole in the retaining plate (Q).
4. Install the retaining plate using (2) #10-24 screws (R) provided. When
installed, the end of the cord’s outer jacket should not extend beyond 1 ⁄
2
”
into the wiring compartment.
5. Tighten the (2) screws
(R) to retain the supply cord.
6. Connect supply power leads to ballast primary leads in accordance with
local and NEC Codes. Place the provided fiberglass sleeving around the
entire length of supply power leads before connection to socket leads.
7. Attach ground lead to green ground screw inside wiring compartment
and replace cover
(J).
Aiming Instructions: (See Figures 2)
Remote unit target aiming is accomplished with the use of an optional
aiming sight bracket
1. To position fixture horizontally, loosen the bolts holding the auxiliary
fitter to the pole or mounting surface and rotate the fixture to the desired
poition. Tighten the bolts.
2. For vertical aiming, slightly loosen the yoke bolts
(L) and the aiming bolt
(J) that holds the preositioning stop bracket (K).
3. Position the fixture to the required vertical angle.
4. Ensure that the stop on the repositioning bracket is resting firmly against
the mounting yoke
(H)
5. Tighten the yoke bolts and the aiming bolt.
REMOTE YOKE HEAD AXIAL OPTICS
INSTALLATION AND SERVICING INSTRUCTIONS